Engine: Factory engine parts revision package I with metal catalytic converter
All our vehicles are revised according to defined standards .
It starts with checking the incoming status of each vehicle. This test includes the following work steps:
Thorough cleaning outside and the interior
Visual inspection of the paint
Visual inspection of the body
Visual inspection of the interior
Functional test of all components such as air conditioning/heating, lighting control units, etc.
test drive
Visual inspection of chassis / brakes / engine
The second step is dry ice blasting. This includes:
Removal of all underbody panels
Dismantle, clean and store all dismantled panels
Drain engine, transmission oil, washing water and brake fluid
Shipment to Steel
Underbody, front, rear and engine compartment dry ice blasting
After dry ice blasting, the scope of the restoration is determined:
Another visual inspection of the underbody for corrosion and damage
Determination of the scope of the body work
Testing of the chassis components
Checking of all lines (brake, fuel, oil, etc.)
Overhaul electronic components depending on defects
Engine:
Manufactory 964 partial revision package
Pressure loss and visual inspection
Dismantle the engine down to the camshaft housings, clean all parts
Check wear parts such as clutch etc. and replace if necessary
Ancillary units such as starter, generator Check and replace if necessary
Check ignition system and replace if necessary
Check attachments for function and replace if necessary
Check blasting of exhaust system and replace if necessary
Transmission:
Check for leaks after visual inspection
Check wear parts and replace if necessary
Landing gear:
Measure vehicle (set height, wheel load, track, camber, etc.)
Test drive / checking all functions / quality check
Demonstration for acceptance of the main inspection, if necessary, entry of individualizations
Before delivery handover inspection
